Niagara Cutter N88628 Cobalt Steel Square Nose End Mill - inch, Weldon Shank, TiCN Finish, Finishing Cut, 30 Degree Helix, 4 Flut

Description

Niagara Cutter has been designing and manufacturing precision cutting tools since 1954. Non-center-cutting end mills are for applications such as peripheral milling and finishing, but cannot make plunge cuts. The end mill has a Weldon shank. The shank is the end of the tool held in place by a tool holder or machine. The TiCN coating offers increased hardness and greater abrasion resistance than uncoated or TiN-coated tools. The number of flutes varies; fewer flutes provide better chip-carrying capacity, while more flutes produce a finer finish. It balances lower angles’ strong cutting edge for difficult-to-machine materials with higher angles’ increased cutting action. Specializing in end mills, cutting mills, and saws, the company is based in New York and manufactures its tools at facilities in Pennsylvania and Massachusetts. Center-cutting end mills can create three-dimensional shapes and profiles, and make plunge cuts similar to a drill bit. If heat is not reduced effectively, the tool’s cutting edges will dull and additional material buildup can occur. They have cutting edges along the outside diameter and flutes that remove chips from the cutting area and allow cooling fluids to enter. The tool’s square end has straight cutting edges that create sharp, unrounded cuts, while the center-cutting design has cutting teeth at the end of the tool that support making pocket cuts, profiling, and slotting. The 30-degree helix angle supports general-purpose applications.

Key Features

• The tool’s square end has straight cutting edges that create sharp, unrounded cuts, while the center-cutting design has cutting teeth at the end of the tool that support making pocket cuts, profiling, and slotting.
• The Niagara Cutter SPC408 TiCN-coated cobalt steel square nose end mill has a 30-degree helix angle for milling a wide range of materials, including high-temperature alloys.
• The number of flutes varies; fewer flutes provide better chip-carrying capacity, while more flutes produce a finer finish.
• The cobalt steel substrate can be run at faster speeds and stays sharp longer than high-speed steel tools, while offering greater resistance to heat and abrasion.
• End mills are designed to remove material and create multi-dimensional shapes and profiles.
• The 30-degree helix angle supports general-purpose applications.